(1) the force of force through the bearing axis as far as
possible, which requires the force point evenly symmetrical and stable,
through the spherical surface or parallel to the axis of the force.
(2)
The size of the force should be smooth and uniform, should not have an
impact, which requires the use of hydraulic or energy to exert a smooth
pull or pressure tools, it is forced to use hammering, but also through
the copper sleeve and other soft Not falling debris metal buffer, tapping force as light as possible. Best to use copper rods or copper hammer for hammering.
(3) to avoid the force through the rolling body, which requires
the assembly and disassembly of the inner ring (shaft ring) through the
inner ring force, when the outer ring assembly and disassembly) through
the outer ring force.
(4)
drag to be sustained to the extent possible, for example, in the
installation of bearings to be installed in the correct position just
stop when the bearing force to ensure that the ferrule (washer) end face
abutment hole or shaft retaining shoulder end face, Neither can be squeezed too tight, but can not fit in place.
CATEGORIES
Latest news
- FB090/FB092 Wrapped Bronze Bearings
- Shock Absorber Upper & Lower Bush
- Hollow Shaft Magnetic Ferrofluid Vacuu
- Bronze Sliding Du Bush Bearing, Bronze
- Magnetic Ferrofluid Vacuum Sealing Fee
- Metal-polymer,Low Friction,Plain Beari
Contact us
- ADD: No.503,Hunan International Commerce Center, Jintai Square,Changsha 410001,Hunan
- TEL: 86-731-84770165
- FAX: 86-731-84770163
- E-mail: sales4@@slide-bearing.com
> Industry news